DST Agitator Drives

DST agitator drives made from stainless steel 1.4435/1.4404 are available as overhead drive or bottom mounted drive. The overhead drive prevents the escape of any hazardous gases or the ingress of contamination during agitation. By using a bottom mounted agitator drive, the agitator is hermetically sealed, thus preventing any escape of the medium.

Materials

  • Standard: 1.4435 and 1.4404
  • Stainless steel: 1.4301, 1.4401, 1.4571, 1.4539, 1.4980
  • Hastelloy: 2.4602 (C-22), 2.4610 (C-4), 2.4819 (C-276)
  • Titanium: 3.7035 (Grade 2), 3.7055 (Grade 3), 3.7165 (Grade 5)

Many other special materials on request.

Overhead Agitator Drives

Overhead agitator drives are applied in the chemical and pharmaceutical industries. They are used in reactors or process engineering machines and enable a powerful, safe and efficient mixing process.

The overhead agitators from DST are characterised by a compact design and connect the motor side with the process side. An agitator drive equipped with a DST magnetic coupling hermetically seals the agitator. This prevents the escape of hazardous liquids or gases and the ingress of foreign particles or substances during agitation. The use of a DST magnetic coupling thereby increases the safety and reliability of agitator drives.

0.1 – 25,000 Nm (up to 500 Nm complete unit, over 500 Nm as special solution)

Highlights

  • Complete unit with support bearing and mounting to suit customers motor
  • Compact design for the laboratory technology
  • High pressures and temperatures possible
  • Everything from a single source
  • Customer-specific solutions

Applications

  • Autoclaves
  • PU industry
  • Chemical industry
  • Laboratory technology

Bottom-Mounted Agitator Drives

Bottom-mounted agitator drives are primarily used in the food and pharmaceutical industries as well as in process engineering for suspending, homogenising, dispersing and emulsifying various substances.

With a bottom-mounted agitator, the inner rotor directly transmits the drive torque of the motor to the outer rotor, while which is immersed in the medium together with SSiC plain bearings. In this configuration, the agitator blades are installed by the customer by welding them to the outer rotor. In addition to the standard versions, preparation for speed monitoring is also possible.

0.3 – 1,200 Nm* (up to 150 Nm including SSiC bearing)

Highlights

  • Very good surface finish
  • Optionally equipped with speed monitoring
  • Canister flange as screw or welding flange
  • Various materials are available
  • Customer-specific solutions

Applications

  • Food industry
  • Pharmaceutical industry
  • Process industry

* <150 Nm incl. SSIC bearing, further bearings made of steel or plastic on request

Contact Us

Quotation request